Installing

Refer to the build process to build the required binaries for installation. Then proceed with the following instructions to deploy uberXMHF on the SD card:

Deploying binaries to SD Card

1. mkdir -p ~/mnt/pi-boot
2. mkdir -p ~/mnt/pi-root
3. sudo mount /dev/mmcblk0p1 ~/mnt/pi-boot
4. sudo mount /dev/mmcblk0p2 ~/mnt/pi-root
5. sudo cp ~/uxmhf-rpi3-staging/uhcalltest ~/mnt/pi-root/home/pi/.
6. sudo cp ~/uxmhf-rpi3-staging/uhcallkmod.ko ~/mnt/pi-root/home/pi/.
7. sudo cp ~/uxmhf-rpi3-staging/uxmhf-rpi3.img ~/mnt/pi-boot/.
8. sudo cp ~/uxmhf-rpi3-staging/config.txt ~/mnt/pi-boot/.
9. Append loglevel=8 memblock=debug dwc_otg.fiq_enable=0 dwc_otg.fiq_fsm_enable=0 to ~/mnt/pi-boot/cmdline.txt
10. sudo cp ~/uxmhf-rpi3-staging/boot/* ~/mnt/pi-boot/.
11. sudo mkdir -p ~/mnt/pi-boot/overlays
12. sudo cp -R ~/uxmhf-rpi3-staging/overlays/* ~/mnt/pi-boot/overlays/.
13. sudo cp ~/uxmhf-rpi3-staging/kernel7.img ~/mnt/pi-boot/.
14. sudo mkdir -p ~/mnt/pi-root/lib/firmware
15. sudo cp -R ~/uxmhf-rpi3-staging/mod_install/lib/firmware/* ~/mnt/pi-root/lib/firmware/.
16. sudo mkdir -p ~/mnt/pi-root/lib/modules/4.4.50-v7+
17. sudo cp -R ~/uxmhf-rpi3-staging/mod_install/lib/modules/4.4.50-v7+/* ~/mnt/pi-root/lib/modules/4.4.50-v7+/.
18. Edit ~/mnt/pi-root/etc/fstab and comment out line beginning with /dev/mmcblk0p1 which is mounted to boot

Boot up and test

1. umount ~/mnt/pi-boot
2. umount ~/mnt/pi-root
3. Insert sd-card into the Raspberry PI 3
4. Power on the Raspberry PI 3
5. … and you should see uberXMHF booting up with debug output and the guest starting soon thereafter